You can now proceed with pairing the Tree devices. Alternatively, a separate line with a higher cross-section can be installed. Especially Tree light fixtures have a higher power requirement that can lead to voltage drop on the 24V lines, and depending on the topology, the achievable line length can be significantly shorter.įor longer distances or higher loads, either use a separate power supply closer to the loads, or split the loads across multiple home runs. length of 500m applies to the communication lines of a Tree Branch, not to the line length of the 24V power supply. This connection is crucial for reliable data transmission. For this all power supply's GND (negative) have to be interconnected. in a sub-panel, or if separate power supplies are used for lighting). This is necessary if more than one power supply is used.
![loxone tree loxone tree](https://www.loxone.com/enen/wp-content/uploads/sites/3/2017/09/tree-floor-plan.png)
Within the enclosure, panel wire is used for wiring.ĭevices that communicate with each other have to share a common GND.
![loxone tree loxone tree](https://www.loxone.com/enus/wp-content/uploads/sites/13/2017/03/LED-Ceiling-Spot-WW-web.png)
We recommend running one Tree Cable from the panel per room and then branching off to the individual Tree devices in that room. For devices with higher power requirements such as Tree lighting products, the Tree Cable also contains a pair of wires with 1.5mm² cross-section (AWG16) for power supply. The Loxone Tree Cable is used for wiring, it contains the Tree communication lines as well as the lines for the 24VDC power supply in the corresponding colors. The following wiring topologies are possible, at a maximum length of 500m/1640ft: The following diagram shows the wiring of several Tree devices connected to two different Branches of a Tree Extension. There must be no connection between different Tree Branches.
![loxone tree loxone tree](https://www.loxone.com/enen/wp-content/uploads/sites/3/2017/03/LED-Spot-RGBW-Tree-1.png)
Up to 50 Tree Devices can be connected to the Tree interface of a Miniserver, or each of the two Branches of a Tree Extension.
#Loxone tree update#
Update and Diagnostics for Tree Devices.The Loxone Tree Interface allows connecting Tree devices, and is provided by the Miniserver, Miniserver Compact, or Tree Extension.